Replacement
-Replacement is a like to like process which means repairing the damaged part by replacing it with its identical new part -The Repair process shall follow ASME PCC -2 |
No. |
Type |
Format |
Subj |
Book Name |
Edit. |
Scope |
Author(s) |
Availability |
1 |
Presentation |
|
Pipeline |
2009 |
This Presentation gives an overview on the different repair methods used in repairing damaged pipelines |
Penspen |
Upon Request |
|
2 |
Presentation |
|
Pipeline |
N/A |
This Presentation gives an overview on the different repair methods used in repairing damaged pipelines |
Abdel-Alim Hashem |
Upon Request |
|
3 |
P |
|
Piping System |
N/A |
The objective of this Document is to carry out the repair or replacement of pipe supports including the portion of pipes touching and adjacent areas to the support |
N/A |
Upon Request |
|
4 |
GL |
DOCX |
N/A |
N/A |
This Guideline is intended to give an overview on the Technical notes to be considered during repair processes |
Mohamed ElGanzory |
Free |
|
5 |
GL |
|
Tank |
N/A |
Requirements governing the installation of a replacement bottom over an existing bottom are given in this document |
N/A |
Upon Request |
|
6 |
GL |
|
Tank |
2014 |
This guide sets out the key features required for planning and executing inspection, maintenance and repair works on aboveground fully supported vertical steel storage tanks Refer to section C3.2 |
EEMUA |
Upon Request |
|
7 |
S |
|
N/A |
2011 |
This Standard provides methods for repair of equipment and piping within the scope of ASME Pressure Technology Codes and Standards after they have been placed in service. These repair methods include relevant design, fabrication, examination, and testing practices and may be temporary or permanent, depending on the circumstances. Refer to Part 1 and 2 |
ASME |
Upon Request |
|
8 |
S |
|
Tank |
API ST 653 Tank Inspection, Repair, Alteration, and Reconstruction |
2018 |
The Standard provides minimum requirements for maintaining the integrity of such tanks after they have been placed in service and addresses inspection, repair, alteration, relocation, and reconstruction. Refer to section 9.13 |
API |
Upon Request |
9 |
S |
|
Pipeline |
1983 |
this British Gas engineering standard defines procedures to be used when dealing with line pipe, used for pipelines and designed to operate at pressures above 7 bar Refer to section 9.4 |
British Gas |
Upon Request |